Форум по компрессорам и о компрессорном оборудовании - отзывы, обсуждения и выбор

Hello,

I need to change the offload time for one compressor Renner RS 55 with controller Rennertronic. Abybody have service manual with the service codes for the controller?

Thank you

http://www.scubaengineer.com/pictures/c ... _03_06.pdf

первые две ссылки - трэш полный, удали.
последняя - да мануал, правада не знаю затерялись ли где там на 85 страницах сервис коды, но это уже другая история.
PS ясно понятно

за чистку мусора - спс. а в мануале найдёт всё, что автору надо.. на крайняк там чётко написано по каким поводам куду звонить, а там, может и коды дадут..)))

Thank you for the information. Unfortunatelly there is no information how to setup the run-on time. It seems that there is another separate manual for the controler only. In the manual it is written:

"A detailed Manual on the RENNERtronic control is enclosed into the package."

Does anybody have this RENNERtronic control manual?

it's a very rare compressor. most often comes not new, and in the same new equipment. original documents (those that come with a new compressor) to find in Belarus is practically impossible. I assume this issue can be addressed by the manufacturers, by personal application to them. faced with a similar task on another compressor: start time made for additional timer built into the control circuit (it there hooked up)..