Страница 1 из 1

bearings Rotorcop NK160

СообщениеДобавлено: 05 июл 2017, 11:53
i_borisov
Hello,
we have compressor Renner RS45 with airend Rotorcomp NK160. Do you know what is the position for the two bearings on the female rotor to be installed? We have two bearings 15245, but I dont understand how to position this bearings. Is there a space sleeve between the two bearings? When I put both bearing on top of each other it seems they do not position right.

Any help?

Re: bearings Rotorcop NK160

СообщениеДобавлено: 06 июл 2017, 09:59
rus331
Здравствуйте,
у нас есть компрессор Реннер RS45 с Rotorcomp винтовой блок NK160. Вы знаете какая позиция для двух подшипников на женскую ротор должен быть установлен? У нас есть два подшипника 15245, но я не понимаю, как позиционировать это подшипники. Есть пространство втулка между двумя подшипниками? Когда я поставил оба подшипника на верхней части друг с другом, кажется, они не правы.

Re: bearings Rotorcop NK160

СообщениеДобавлено: 06 июл 2017, 12:25
kudr
Hello!
You have tapered roller bearings. They are installed in pairs to compensate for the axial forces, since they operate only in one direction. You should install the bearings with small diameters of the cones out. That is, turn over the top bearing

Re: bearings Rotorcop NK160

СообщениеДобавлено: 07 июл 2017, 11:09
ASHKARUPA
rus331 писал(а):Здравствуйте,
у нас есть компрессор Реннер RS45 с Rotorcomp винтовой блок NK160. Вы знаете какая позиция для двух подшипников на женскую ротор должен быть установлен? У нас есть два подшипника 15245, но я не понимаю, как позиционировать это подшипники. Есть пространство втулка между двумя подшипниками? Когда я поставил оба подшипника на верхней части друг с другом, кажется, они не правы.


Есть мнение, что все умеют пользоваться переводчиком))
Было бы больше смысла, подправить грамматику.

Re: bearings Rotorcop NK160

СообщениеДобавлено: 07 июл 2017, 11:12
ASHKARUPA
This is 1 of the modification NK160.
Maybe you help.

Re: bearings Rotorcop NK160

СообщениеДобавлено: 21 июл 2017, 00:12
i_borisov
Hello,

thank you ASHKARUPA, but in the manual it is written "set of bearings" and it does not show how these bearings should be installed.

Thank you kudr for clarifications, but I want to ask you in case we install the bearings with small diameter out, then the outer ring of the top bearing will be loose. The locking nut will be pushing the inner ring and the outer ring will be loose. Are you sure that the bearings should be installed like on the picture?